Dewalt 20v Lithium battery to Milwaukee V18 Nicad tool adapter

Description

Adapter, filament, and Brass connectors Made in the USA!
1 adapter that does it all!
For use on the Milwaukee V18 tools(older) Will not work on M18 (newer tools)
This is a PETG 3d Printed
Dewalt DCB203 or DCB200 lithium battery to NI-CAD  Milwaukee V18 tools.
adapter ready for use on drill(model 0624-20), Also Milwaukee 1st V18 lithium ion drill (0824-20), flashlight(Model 49-24-0165),Impact Driver (0881-20), sawzall(model 6514-20),
circular saw(6310-20)
,  Rotary Hammer(5361-20) and Sawzall(6515-20)
. I can't guarantee that it will fit all the Ni-cad tools, I don't own all the tools to check first. If you come across tools that it doesn't fit please contact me so I can make a list that it doesn't work with and/or adapt the adapter. (
LOCKS in place NO modifications to tools)
Pictures show the tools I own that it fits.
Complete adapter ready to rock and roll.
There are a lot of other adapters out there.  If you choose to go with another one make sure you pay attention to
depth of cu
t
on the circular saw.
I have only used the adapter with the batteries mentioned above.  It is always good practice that when the tool starts to die that you stop and replace the battery don't wait till the tool won't run it could cause battery damage.  Dewalt has lot of different batteries I have only used the two listed.  I haven't tried the flexvolt batteries at all and wouldn't not recommend them.
Must remove adapter before charging.  Only use charger made for the new battery.  Example  Nicad/Nicad or Lithium/Lithium.  Not Lithium on Nicad.
Not responsible for Misuse/tool or battery damage
Do not store in above 100 degrees  example: hot car with sun beating down
For international buyer is responsible for any customs, duty,
tariff
charges.
(This does not come with batteries or tools just adapter)
Instructions:
1.  Insert tool first all the way(if the tool isn't all the way in the battery will not go in all the way)
2.  Insert battery it will need some pressure to push up the locking mechanism.  Push until the battery locks in place.
If it is really hard to push up make sure the tool is all the way in.
Tool removal:
1.  REMOVE Battery first
2.  Then remove the tool.
Very simple to operate please send me an questions or concerns so I can correct any issues that come up!  Thank you